output

Hey all, I picked up a 91 Streamer Stage II 5 string a few months ago. I absolutely love this bass. The feel, the tone, the looks it has it all. My only issue is low output on the D and G strings. The bass came with the MEC pre amp and Seymour Duncan pickups. I have tried adjusting pickup...

Hello! Long time lurker, first time poster. Happy to be a part of the community now! I have come into owning an all original 1990 Thumb 5 NT(rad!) in pretty amazing shape for being 30yrs old. I've owned a few in the past(Corvette $$, Thumb B.O. 6), but this one'll be the lifer, caught my white...

Hi there, I've got 3 Warwicks. One, a Corvette with MEC Dynamic pups, has low output compared to my other Warwicks; Streamers. The set-up is about the same, so the pup height is about the same. I've changed the battery and tested/compared them in both active and passive mode. I've also...

Hello everybody. Sorry in case I posted double topics, I did't find nothing that matches my needs... I have a couple of questions and I try on the forum, 'cause at Warwick no one replied to me :( 1) Are the spare bronze frets sold on the site, the only ones, suitable to re-fret my 1990...

ok - my first thread. being rickenbacker player for almost 20 years i'm used to two channels output. for both recording and live. some time ago i acquired a thumb 4 nt w/ mec electronics. and i miss one channel for each pickup. very much it would be great if anybody has idea/experience...

i've noticed that the output of the bridge pickup on my fretless is a lot lower than the neck pickup...even bearing in mind position and type of pickups it strikes me as very quiet. anyone have any experience of this ?

hi everyone...I own an Infinity NT(5 String) and have a problem with no sound output on the guitar....I put in a new 9 Volt battery...guitar cable good..amp fine...works with my other Thumb NT. is it possible it could be pre amp? Any suggestions on what could be wrong would certainly be...

Hi, wondered whether anyone could advise me on a problem I have with my '89 Streamer. When first plugging in to my amp, I set the pre gain as normal but after say half an hour of playing, I notice an audiable drop in volume and I have to turn the pre gain up nearly a quarter of a turn to get...

Hello! I have a 4-String Thumb Bolt-on with the problem of a very low output signal when running it active. The passive signal is much much higher; the active signal is really too low to use it. At first I changed the Battery several times and after that i checked also the batteries...

Hi there, I recently bought a used Dolphin Pro II - it''s obviously not what a Dolphin I would be, but it offers very nice quality and action for the money I paid (350 €). The only thing that strikes me is its output level: Even though it's active, it is very quiet and I have turn up my...

Hi! a simple question. Tubepath 10.1 is rated 1000W @ 4Ohm, what would the output be @ 8 Ohm? My guess is somewhat 30% less. But it is just a guess :) Thanks. =g=

Quick question for you guys. I've got a Corvette with active pups and preamp. With the preamp set flat should the output be more than, less than, or the same as the bass set to bypass mode? The issue I have is that in active mode my bass doesn't have enough output to drive an auto wah pedal, but...

I got "some" Warwicks, you can see my list below, I found that Thumb Bass is not as loud as Streamer I or II and also compare to my Status bass. At first, the small output shouldn't be a problem, I may just turn the amp louder...but the output compare Thumb & Streamer is way different, The...

Hi, I'm a new Warwick owner and was just finally able to get the bubinga Corvette Std 6 string I've been lusting after for ages. :) I really like the bass, I have it set up and playing beautifully. Great work, Warwick! I've noticed only one down side - it seems like the output level is really...

I recently purchased a Combo 25.2 and first impressions were that this was and excellent amp. However, the first time in the studio and the amp blew on me. I took the amp back to the shop and they replaced it; no questions asked. Next time in the studio, the amp blew again!!! This time the shop...

My Thumb's output jack is loose. When I plug a cable into the output jack it sits very loose and often does make a proper connection. Before I go taking the jack out for inspection, can these be repaired or adjusted or do I simply need to order a new jack, and if so does it have to be a...

Hi all, just wondering if anyone knows what the power output is at 8Ohms with the Xtreme 5.1 and 10.1? I can't seem to find it anywhere. Cheers, dave.

The volume of my Thumb 6 BO is much smaller than my other bass, it got Bassline Soapbar and 2 band MEC on it, I tried reset the stings and PU but didn't help much. My other Warwick got EMG and Bartolini PU, maybe bassline just got small output or the EMG and Barts just sounds big........I...

Hi, I know it's a topic that has been discussed before, but maybe you guys can help me clear up some uncertainties. I've heard and read that there is an option to adjust the output of the pre-amp. Tuesday I've received my SSII and yesterday the seller told me that a technician had lowered...

Hi, I want to record some bass tracks with my active bass. I pluged the cable into line in of the mixer and set the active level to minimum. But at heavy picking the bass still overdrives a bit. Are my strings too close to the pickups (I lowered them a bit) or should I use an additional...