wiring

hey all, new here. I just repaired/refinished a Fortress one, And All photos i took of the elctronics are gone,...so im at a stop, Does anyone Have Photos Or a Wiring diagram of A Fortress One?????????????? any help appreciated

Hi, I'm the proud owner of a RB Corvette $$ for about 8 month now. Coming from a cheaper 5-string this was real improvement and I liked that bass from the start, but there were also some points that I found... well, not dissapointing, but improvabel: - not enough growl on the deep side...

I found that the single coil on the TJ on my Dolphin SN is a bit thin, just too close to the neck. I have heard that the pups can be flipped, making the coil nearest the neck the one selected in single coil mode. I tried this today, and i just dont have the spare cable in the compartment (damn...

I'm putting together a re-finnish/re-wire/custom plate job on a old german no-name fretless p-copy and have big dreams for the wiring which i am not sure are possible. its for a mate (essentially a pratice for learning to mod and make basses) and i wanna make it something special. here...

Oh so it's about 2 days before my first gig in 6 months and my bass just decides to go all quiet on me and suddenly. So i switch the bass back to passive and it works, so i take the battery out and test it, still good, change the battery and it starts heating up heaps and the bass starts making...

Just about to attempt to upgrade the passive elecs in my Streamer Std 5 with a Bartolini 2.2AP active pre-amp. Only problem I have as a guitar elec newbie is that the new pre-amp reckons on connecting only one 'hot' wire from existing (passive) pickup - this is a single yellow wire on the...

New guy with a problem... I managed to rip out the battery from my '96 Corvette Standard 5. (Don't ask!:roll:) I have looked at the wiring schematics on the site and can't find one that matches the configuration and colors that I have inside...and I don't know where the wires came loose...

I need a older wiring diagram for the dolphin pro 1 93. I thought I had came across it somewhere but cannot find it now. All I can find is the diagram that was updated in 07. is the only one I can find. I don't have that new pc board. the wires comming off my board are purple orange brown...

Any ideas on how i would add an output for a secondary cab to an older CCL? I think the newer ones can be run with an external cab and i would like to do the same with mine. If the std speaker is 8 ohms i should in theory be able to drive a second 8 ohm load with the amp if the amp can handle...

This message is specially to Florin...! I'm the lucky owner of a WAMP800, - it's a great amp...! But I have some small troubles, and I can se that you have emailed a wiring diagram to "bassman1de" for a long time ago. I would be a happy man if you could email me the same wiring diagram...

have anyone may have a wiring diagram of the Streamer Stage 1, 1990

I need a wiring diagram for a Rock Bass corvette standard ASAP. Thanks

Does anyone have the Wiring Diagram for a Rock Bass Corvette Standard. Mine is on the fritz and need to get it back into working order ASAP. Thanks

hey i have an idea: picture this:...a bass with 2 MM style pickups or dual coil...with 3 band of EQ. the MM style humbucker ,can be wired in series,parallel,and single coil. plus you got the 3 band eq'' low,mid,hi'' ok now to the point... you can do this with the bridge humbucker...

Hey guys, The wiring diagrams for the LTD editions are now available on the main page: Enjoy :-)

Hallo everybody! I recently bought a 1992 Streamer Stage I with weird non-original electronics (they are volume/volume/tone/tone!!!), and I bought Mec 3 way electronics to replace them, and I'd like to try to do it by myself. The instructions that came with the product are not clear to me...

I bought a used '97 corvette standard about two months ago. It was working fine until the other day when it started making loud buzzing sounds. With further inspection, it seemed the jack was loose and one of the wires that attaches to the jack was disconnected. I tightened the jack and placed...

Hi all, Ive just emailed Warwick to see if they can help but I thought I'd see if the answer lies in this vortex of Warwick knowledge. I bought some active MEC electronics for my passive corvette. The jack that came with the electronics is too shallow to fit through the hole in the body...

if i change the wiring around so the back pick up is in the front and the front pick up is in the back will that be fine to do. I have a rock bass 4 string acttive pick up they are MEC. The reason i want to do this is so i can have more highs come out i play close to the neck. the further back i...

I have a quick question for anyone who has a Corvette with active J-style pickups: Is the red wire the output and the white wire 9V? Or is it the other way around? I'm assuming the shield on the white wire is ground, but I can't seem to find anything to indicate which is which for power and...