Warwick dolphin

steve-norris said:
Doog said:
The one thing I really wish the Dolphin SN had is the fret markers. I love them.

apart for the reaction from females....Arrrrr iklle dolphins, sooooo cute!


Well they are cute I guess, from a certain point of view. But then you stand said females in front of your amp stack, turn it to 11, and let them hear how cute this Dolphin sounds. Of course Dolphins are cetaceans, so growling like a killer whale aint too off the ball. Alas some females will then want to spend the rest of the night sitting on your speaker cab. :shock:
 
steve-norris said:
warwickhunt said:
With regard to value, I'd not part with my Dolphin for less than a 4 figure sum... and even then I probably wouldn't. What's a Bongo worth £500-£600! A bargain I reckon.

The tuners aren't original, they would have matched the bridge and knobs. I tend to refer to that finish hardware as gunmetal. I really couldn't say with any conviction whether the new hardware is exactly the same colour as the old. I'd be inclined to buy a single item if possible (rather than the full set) to see if it matched.

You are fine dropping just about any preamp in you'll just have to get your head around wiring for the dual-concentrics. Be sure to check out the schematics on the Warwick site, it'll help a lot if you go that route.

Nice trade!

arrh the resident www.basschat.co.uk warwick expert! to be honest i will most likley just order a full set, i have just ordered a truss rod cover and a set of screws/bolts from the Warwick shop, the tuners were only about 6 euro each! I am going to order some frets/ pots etc in the new year so i will save a bit on the postage.
The other thing that caught my eye was a set of very nice control knobs with dolphin inlays to match the board very tempted untill i saw the price nearly £100 for a set of knobs :shock:

Hi Steve :)

You're probably right just ordering everything together. I'm ordering a whole set of hardware for my SSI Pumpkin bass for when it goes back together and I'm ordering screws and another nut etc just for spares. My only concern for your bass was that the new knobs might not quite be the same finish as the bridge (by the same token, they might). Saying that if you bought the 'CS' inlay bits it wouldn't matter... go on bling it up! Actually don't, it'll look a bit OTT.
 
Back
Top