- Joined
- Dec 13, 2025
- Messages
- 1
- Reaction score
- 0
I've just been down this crazy 'rabbit hole' journey following the recent purchace of a Warwick Streamer Stage 2 (2002) and I experienced the D & G strings were very weak and thin sounding compared to the others. The EQ points on the preamp too were just not doing it for me either, however i did not want to loose the essence of the bass, especially that lush midrange growl.
So far I tried EMG JA (alnico magnets) with a Bart preamp (3 Band NTMB+FL Preamp, 4 Pots - HR-4.6FL (#HR-4.6AP/918FL): Active/Passive)
800hz mid range did growl but not in the same way as the MEC set up. I just could not settle with it, the low end and response to playing seemed too smooth and 'buttery' if thats a word to describe something. Maybe a bad match with the pickups, maybe pickups were a bad match with the bass. Time I moved on.
Next step I thought lets try some Bartolini 9CBDJ pickups with the Bart preamp - even worse. Too dark and yes they sound like Barts do, it's a tone some like and I have should have known better, not for me and a lot lower output as they are passive.
So next I thought, It has to be the preamp.. So after lots of consideration and wanting more specific EQ points i went for a Noll - Klaus Noll is awesome and helped with the right one, I went for a TCM 4XM. Four EQ points, clear and dynamic (not 'buttery' like the Bart pre), however after a few band rehearsals I still could not live with the Bartolini 9CBDJ. For me they do not sound like the Streamer Stage 2 should sound like. Much better and stronger tones from the D & G strings but again, something not right here.
Final step and the one that has made me feel like my stage 2 is now better than ever.
Active EMG JX with the Noll TCM 4XM - The tone and the growl is back, the preamp is great. All strings are well balanced and punchy. Bump up the 400 and the 1.3 khtz just a touch and it growls like never before, I can't put it down.
Even though it has cost me some £$€ It has been a good learning curve and sharpened up my soldering skills. if this post can help anyone then great, I searched high and low across the internet with quite often confusing, limited or bad advice given.
So to end, the active EMG JX are stacked coil just like the orginal MEC's are and this is really the type of pickup that is needed with this bass. The Noll preamp has given a wide variety of tone options that were not there before. I'm sure now this combination is possibly the best upgrade for a Warwick Streamer Stage 2.
Your opinion however may vary
Good luck!
So far I tried EMG JA (alnico magnets) with a Bart preamp (3 Band NTMB+FL Preamp, 4 Pots - HR-4.6FL (#HR-4.6AP/918FL): Active/Passive)
800hz mid range did growl but not in the same way as the MEC set up. I just could not settle with it, the low end and response to playing seemed too smooth and 'buttery' if thats a word to describe something. Maybe a bad match with the pickups, maybe pickups were a bad match with the bass. Time I moved on.
Next step I thought lets try some Bartolini 9CBDJ pickups with the Bart preamp - even worse. Too dark and yes they sound like Barts do, it's a tone some like and I have should have known better, not for me and a lot lower output as they are passive.
So next I thought, It has to be the preamp.. So after lots of consideration and wanting more specific EQ points i went for a Noll - Klaus Noll is awesome and helped with the right one, I went for a TCM 4XM. Four EQ points, clear and dynamic (not 'buttery' like the Bart pre), however after a few band rehearsals I still could not live with the Bartolini 9CBDJ. For me they do not sound like the Streamer Stage 2 should sound like. Much better and stronger tones from the D & G strings but again, something not right here.
Final step and the one that has made me feel like my stage 2 is now better than ever.
Active EMG JX with the Noll TCM 4XM - The tone and the growl is back, the preamp is great. All strings are well balanced and punchy. Bump up the 400 and the 1.3 khtz just a touch and it growls like never before, I can't put it down.
Even though it has cost me some £$€ It has been a good learning curve and sharpened up my soldering skills. if this post can help anyone then great, I searched high and low across the internet with quite often confusing, limited or bad advice given.
So to end, the active EMG JX are stacked coil just like the orginal MEC's are and this is really the type of pickup that is needed with this bass. The Noll preamp has given a wide variety of tone options that were not there before. I'm sure now this combination is possibly the best upgrade for a Warwick Streamer Stage 2.
Your opinion however may vary

