Streamer Jazzman Owners, HELP! (Or any electronics expert)

[FunkyMan]

Hello Brothers! Recently I made a stupidity in my bass, changing the MEC preamp for an Aguilar Pre, which was just a usefull move, didn't like it, MEC stuff are just perfect for W Basses.

So i reinstalled the old MEC Pre in my Streamer Jazzman, according to the Diagrams provided from MEC and Warwick Websites, and i soldered everything fine, except all the grounds, i don't know where and how to connect them... the bass is sounding, but the 3 EQ Knobs doesn't work, i tried to connect all grounds to the bigger leg of the output jack, and nothing happens, even a strange noise came after! (I forgot to take note:roll::roll

So the main problem is that i need to know especifically how to weld each ground from each piece of the overall electronics.

i've already sent a e-mail to Vlado Hansal from MEC, but i would like to have several opinions just in case! Thanks.. if you need pics just tell me!

 

[schlobodan]

well I can make a pic off the P-Nut 1 electronics, should be the very same electronics

 

[FunkyMan]

well I can make a pic off the P-Nut 1 electronics, should be the very same electronics

Please Bro, i've emailed everywhere with no avail yet, Take closer pics from different angles! And thankyou very much in advance!

 

[Augie]

I'll get some pics of my jazzman for you tomorrow if you like. the P nut may have SD electronics....not sure.

 

[schlobodan]

this is the regular MEC

 

[thefitz]

I'll get some pics of my jazzman for you tomorrow if you like. the P nut may have SD electronics....not sure.

The P-Nut 3 has the SD electronics, the other two I think are standard MEC.